Table of Contents
Advertisement
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting bit protrusion
1
2
► 1 . Base 2. Scale 3. Bit protrusion 4. Clamping screw
To adjust the bit protrusion, loosen the clamping screw
and move the tool base up or down as desired. After
adjusting, tighten the clamping screw firmly to secure
the tool base.
Switch action
1
► 1 . Switch lever
CAUTION:
•
Before plugging in the tool, always be sure that
the tool is switched off.
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing trimmer bit
3
4
► 1 . Loosen 2. Tighten 3. Hold
CAUTION:
•
Do not tighten the collet nut without inserting a
bit, or the collet cone will break.
•
Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
OPERATION
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward
over the workpiece surface, keeping the tool base flush
and advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
► 1 . Workpiece 2. Bit revolving direction 3. View from
the top of the tool 4. Feed direction
4 ENGLISH
2
1
3
4
2
3
2
4
Advertisement
Table of Contents
