Operating Controls - Bunn Titan Dual Installation And Operating Manual

LARGE
SMALL
F
A. MAIN ON/OFF SWITCH
This switch, located under the brewer in front of the right rear leg, turns
power on and off to all components in the brewer.
B. ON/OFF SWITCH (ENABLE BREW)
Pressing the "ON/OFF" button will alternately turn the selected brewing
side on and off. Pressing this button during the brew cycle will interrupt the
brew cycle, stopping the flow of water. Pressing this button during program-
ming of the brewer will exit the setup and return to the main screen.
C. PROGRAMMING (left)
This hidden button can be used to scroll backwards through the function list while in programming mode.
D. BREW
When the ON/OFF switch is ON and the main screen is visible, momentarily pressing and releasing this
button will begin a brew cycle on the selected side.
E. PROGRAMMING (right)
Pressing and holding this button allows entry into the programming menus. Pressing and releasing the but-
ton steps through each function screen while in the programming mode.
F. BATCH SELECTOR SWITCHES
Pressing the button corresponding to the Half or Full batch selects the amount of product to be brewed on
the selected side. Pressing a different button after a brew cycle has been initiated does not change the brew
batch in progress. Light indicates the selected batch to brew. Also used in programming to adjust settings on
both batch sizes.
G. FUNCTION SCREEN
This is the display which shows the various functions of the brewer and allows the programming to be ac-
complished.
H. FUNCTION SCREEN SWITCHES
These are hidden switches which are used to program the brewer when in the programming mode.

OPERATING CONTROLS

B
C
READY TO BREW
ENABLE
ON / OFF
WATER TEMP: 200°
BREW
BREW
D
G E
H
Page 7
B
ENABLE
ON / OFF
BREW
LARGE
BREW
SMALL
D
F
P3894
40119 071107