Brother HL-3260N User Manual page 214

O p e r a t o r C a l l M e s s a g e
O p e r a t o r C a l l M e s s a g e
O p e r a t o r C a l l M e s s a g e
NO SP-5000
Install the Interchange unit
NO BU-5000
Install the Bridge unit
NO FS-5050
Install the Finisher unit or check your
printer driver is configured correctly
CARD ERROR
An error when accessing the Flash card,
check the driver is formatted and not in
Write Protect mode
CARD REMOVAL
The Flash card was removed while the
printer was powered on. Power cycle the
printer
BUFFER ERROR
Check the cable connection between the
computer and printer
DOWNLOAD FULL
The download buffer of the printer is full.
Add more memory to the printer
FONT FULL
The font memory area is full. Delete fonts
or add more memory to the printer.
IGNORE DATA
Check that the correct driver is being
used and/or try adding more printer
memory.
MEMORY FULL
The printer memory is full and the printer
is unable to print the page. Add more
memory.
PRINT OVERRUN
Select a lower resolution or set the page
protect option in the driver to the correct
size.
A c t i o n
A c t i o n
A c t i o n
There is no Interchange unit. Install the Interchange
unit.
There is no Bridge unit. Install the Bridge unit.
There is no Finisher unit. Install the Finisher unit.
It is impossible to access the card. Turn off the printer
and then turn it back on again.
The card was removed while the printer was turned
on. Turn off the printer and then turn it back on again.
Interface communication error. Check the interface
setting.
Download font overflow. Add memory.
Download font overflow. Add memory.
Postscript error occurred. Add memory.
The memory is full. Add memory.
There is an error inside the printer. Use a lower
resolution or set the page protection to the correct
size for the paper size you are using.
6-3
CHAPTER 6 TROUBLESHOOTING