Eastwood 20521 Instructions Manual page 8

OPERATION
FIG. 3
1. Position the workpiece between the jaws then rotate the Handle [C] in a Clockwise direction
while holding the workpiece in place with the opposite hand. As the moving Jaw begins to
exert pressure on the workpiece, remove your hand from the workpiece and continue to rotate
Handle [C] bending the workpiece as you go.
NOTE: The 8mm Shear Pin in the joint of the Drive Bar and Upper link is designed to fail under
excess pressure. If replacing, use a softer material 8mm pin or mild steel bolt (FIG 3).
2. As the desired bend is achieved, stop Clockwise rotation and reverse rotational direction of the
Handle to release the completed workpiece.
8
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
8mm
Shear Pin
Record This Dimension
"Depth of Bend"
Gauge
Drive Bar