Table of Contents
Advertisement
FIG. 2
Stop
Gauge [G]
Screw [H]
Wingnut [I]
1. Thread the Stop Rod Locknut [F] onto the Stop Rod [E].
2. Thread the Stop Rod with Locknut [E,F] into threaded hole in side left side of the
Bending Brake Unit - [A] (FIG 2).
3. Tighten Locknut [F].
4. Slip Workpiece Stop [G] over Stop Rod [E], place Stop Clamping Screw [H] through hole
then thread on Stop Clamping Wingnut [ I ].
The Eastwood Metal Bender is now ready to use.
6
Stop Rod [E]
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
Lock Nut [F]
Advertisement
Table of Contents
