Programming; Programming The Remote-Receiver; Programming The Light - weinor BiLine Combio-868 LED Assembly And Installation Instructions Manual

BiLine Combio-868 LED
6

Programming

6.1

Programming the remote-receiver

The system is usually supplied pre-programmed. Therefore, when the system is
delivered, all the components can be controlled with the hand transmitter supplied. On
rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver
and setting them to various functions.
6.2

Programming the light

In the case of receivers that have already been electrically installed, briefly disconnect the
1.
power supply immediately before programming.
Start programming mode: within 5 minutes of disconnecting the power supply, press the
2.
LEARN key (1) for 2 seconds on the hand transmitter. The remote-receiver then enters
programming mode for about 2 minutes. During this time, the light alternately switches on
and switches off himself.
3. The light is in programming mode when its brightness alternates between 100% and 50%
power.
4. On the hand transmitter, select the channel you want to use to program the lighting (e.g.
Channel 2).
5. Within the first second during which the lighting brightens to 100% power, briefly press the
UP key. The receiver confirms this command by briefly switching off and then on.
6. Then, within the first second during which the lighting dims to 50% power, briefly press the
DOWN key. The receiver confirms this programming by briefly switching off.
Initialise any other transmitters that are being used.
Finally, check that the lighting have been successfully programmed.
Item number 116739-0000
Version 2 15.11.2013
1
We reserve the right to make technical
changes
Page 9/24
Assembly and installation instructions