weinor WeiTronic Remoto 1M Operating Instructions

Operating Instructions

Handheld Remote Control
WeiTronic Remoto 1M
Nameplate
The nameplate is located on the
back of the handheld remote
control (see Fig. Changing the
Battery).
Approved Use
The WeiTronic Remoto 1M hand-
held remote control is solely
designed for the purposes of
controlling sun protection sys-
tems such as lamella outdoor
blinds, roller blinds, and jointed
arm and vertical awnings.
Technical Specifications
Nominal voltage
Battery type
Protection class
Ambient temperature
Radio frequency
Dimensions
Weight
Selecting the Operating Mode
• Manual operation: manual commands
such as , , are selected by pressing
the relevant button.
• Automatic operation: manual com-
mands plus automatic sun control.
• To change the operating mode, press
the Select button (8) (for longer than
1 second.
• Changing from manual to automatic
operation will cause the products to
retract.
Transmission Check
The channel display doubles up as the
transmission check. Should a radio signal
be received, this will be signalised by
flashing. Should the battery performance
run down, the brightness of the display
will dim and the frequency range will
drop. If the control lamp stop flashing
when a button is pressed, the battery will
need to be replaced.
Automatic Wind Control
When there is a risk of high winds, the sun
protection system will retract and remain
shut down for approx. 15 minutes. Should
the or button be pressed during the
shutdown period, the product will move
very slightly to signal that the system is
still shut down. Please note: The automatic
wind control cannot be deactivated.
www.weinor.com
3 V DC
Coin cell 2430
IP 20
–10 °C to 55 °C
868.3 MHz
118 x 53 x 21 mm
80 g
(1) Channel display
(2) Operating mode display:
(3)
(4)
(5)
(6) Rocker button Up
(7) Rocker button Down
(8) Selection button for
* Lux, Tempura
Lux and Tempura
Jointed arm awnings are also available as
extras with lighting (Lux) and heating
systems (Tempura).
• To activate these options, press the
button (for less than 1 second).
• Hold the or button down to dim
the lighting.
• Press the button to switch off either
the lighting or the heating.
Manual
Automatic
Up On/Brighten*
Stop Off*
Down On/Dim*
Brighten*
Dim*
operating mode
or