Safety Notes; Fundamental Safety Notes; Dangers Of Electricity; Intended Use - weinor BiLine Combio-868 LED Assembly And Installation Instructions Manual

BiLine Combio-868 LED
2

Safety notes

2.1

Fundamental safety notes

•
Keep unauthorised persons away from the unit until it is ready for use.
•
The connected electrical load must tally with that listed in the technical data.
•
The regulations of the local energy providers and the VDE 0100 provisions for humid and wet
areas must be observed.
•
Only connect the remote-receiver to devices approved by weinor.
2.2

Dangers of electricity

•
Work involving connections to 230 V mains may only be carried out by a trained electrician.
•
Disconnect the unit from the power supply before performing any work.
•
weinor recommendation: a residual current circuit breaker (trip switch) should also be fitted to
protect the indoor installation.
2.3

Intended use

The Combio-868 LED remote-receiver is exclusively intended for controlling the weinor lighting
system.
2.4

Improper use

The remote-receiver may only be used on the condition that a malfunctioning hand transmitter or
remote-receiver does not pose a danger to people, animals or objects. The device may only be
connected to devices and units approved by weinor. The system may not be operated in areas
where the transmitted signals might interfere with other devices (e.g. in hospitals or at airports).
Item number 116739-0000
Version 2 15.11.2013
We reserve the right to make technical
changes
Page 4/24
Assembly and installation instructions