Programming The Transmitter - weinor BiEasy 5M Operating Instructions Manual

0800 328 6250
Group control unit
A group is understood to mean the control of several receivers
at the same time. The selected group is controlled by a travel
command. All 5 channels (transmitter) can be used for the group
control.
Any number of receivers can be programmed and controlled in each
channel.
Selection button
Pressing the selection button briefl y allows you to select from
5 channels. The various channels are indicated by the LEDs in the
channel indicator lighting up.
An additional channel is reserved for the central channel to which
all the individual channels are assigned automatically. When
the central channel is selected, this controls all radio channels
simultaneously. This is indicated by all fi ve LEDs lighting up.
Pressing the selection button briefl y allows you to query the
current status (automatic/manual) of the programmed receivers
(bidirectional receivers only) and the hand-held transmitter.
Pressing the selection button for longer (approximately 1 second)
switches off automatic mode of the current bidirectional channel.
The operating mode indicator lights up red. → The receiver now
only carries out manual travel commands and does not respond to
automatic travel commands.
Note
Upward travel of the receiver is initiated when the automatic
system is activated.
Pressing the selection button for longer (approximately 1 second)
switches on automatic mode of the bidirectional channel. The
operating mode indicator lights up green. → The receiver now
executes automatic and manual travel commands.
0800 328 6250
10 | EN © weinor GmbH & Co. KG
Explanation of functions
Pressing the selection button in the central channel for longer
(approximately 1 second) changes the Auto or Manual operating
mode for all the individual channels. A different operating mode
for individual channels (auto and manual) is set on switching for all
channels to Auto operating mode.

Programming the transmitter

Requirement
The receiver is installed. Check whether the channel has been
deleted.
Stand in front of the blind to be programmed while programming.
1. With receivers which have already been installed, switch the
circuit breaker off and on again after a few seconds.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button P on the back of the unit briefl y
(approximately 1 second) until the status display lights for a
short time. The blind moves up and down for approximately two
minutes, showing that the receiver is in programming mode.
3. Press the UP button as soon as the blind starts moving in Open
direction (within 1 second at the most). The status display lights
briefl y.
The blind stops briefl y, starts moving again, stops and then
moves in the Down direction.
4. Immediately (within no more than 1 second) after down travel
has started, press the DOWN button. The status display lights
briefl y. The blind stops. The transmitter channel is programmed.
Note
The blind must be programmed again if it does not stop.
A bidirectional programming process in the hand-held
transmitter can be cancelled by pressing the STOP button for
6 seconds.
© weinor GmbH & Co. KG
www.samsondoors.co.uk
www.samsondoors.co.uk
EN | 11