Table of Contents
Advertisement
Available languages
Available languages
BiLine Combio-868 LED
4
Getting started
4.1
Pre-programmed system
The system is usually supplied pre-programmed. This means that all the components can be
controlled with the hand transmitter supplied. In this case, once the system is assembled and
installed, you can immediately start using the remote-receiver and check that all the functions
are working properly.
4.2
Unprogrammed system
On rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver and
setting them to various functions (see Section 3).
4.3
Checking the functions
Once all the installation work is completed, you will need to check that the system is working
properly and that the individual components are paired.
What to check
•
Is the light working?
•
Can the light be dimmed?
Table 2: Checking the functions
If the components do not react as expected, check the table below to locate the likely cause.
Item number 116739-0000
Version 2
15.11.2013
How to do it
Double-click
Press and hold the UP key
Press and hold the DOWN
key
We reserve the right to make technical
changes
Page 7/24
Assembly and installation instructions
Outcome
The light switches on.
The light gets brighter.
The light gets darker.
Advertisement
Chapters
Table of Contents
