Server Detect; Service Tools - Bunn Dual SH Installation And Operating Manual

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

SERVER DETECT

This function allows the operator to prevent the
start of a brew cycle if a Soft Heat
positioned correctly on the brewer.
SERVER DETECT ?
Procedures to set server detect:
1. Press and hold the ® pad until the display reads
SET NEW RECIPES. Release the ®. Press and
release the ® pad until the display reads SERVER
DETECT.
2. The NO or YES flashes to indicate the current
selection.
3. Select YES to prevent brewing if the Soft Heat
server is not correctly positioned on the brewer
beneath the funnel.
NOTE: If YES is selected and a brew cycle is attempted
with a server not properly placed, the display will read
SERVER NOT IN PLACE.
4. Select NO to allow brewing without a Soft Heat
server in place. This is selected when brewing into
a container other than a Soft Heat
5. When finished, press and release DONE. This will
save the new setting, exit the function screen and
advance to SERVICE TOOLS. Another alternative
is to press either of the
front switch panel to exit the SERVER DETECT
function and return to the MAIN SCREEN.
® server is not
P2310
®
®
® Server.
pads located on the
Page 32

SERVICE TOOLS

This function allows the testing of individual com-
ponents and the ability to check switches for proper
function. This function also tests the Soft Heat
status on the brewer (in place or removed), and the
funnel sensor coil's frequency (diagnostic tool for
troubleshooting purposes only).
® server's
P2311
29877 121302