Brew Counters (View/Reset); Funnel Detect - Bunn Dual SH Installation And Operating Manual

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
BREW COUNTERS
This function allows the operator to track the
number of brew cycles completed on the left side, the
right side, and the total of both combined. There are
three resettable counters, and one life counter that is
not resettable.
Procedures to view/reset the brew counters:
1. Press and hold the ® pad until the display reads
SET NEW RECIPES. Release the ®. Press and
release the ® pad until the display reads BREW
COUNTERS.
2. Pressing NO in this screen will advance to the next
function. Press YES to view the first brew counter
(left). This number represents the brew cycles
initiated since that counter was last reset.
3. To advance to the other counters, press and re-
lease NEXT. The four counters are as follows:
LEFT - total brews on the left side (resettable)
RIGHT - total brews on the right side (resettable)
LEFT AND RIGHT - total brews on the left and right
sides combined (resettable)
LEFT AND RIGHT - total brews on the left and right
sides combined (non-resettable)
4. To reset any of the counters to zero (except for the
non-resettable counter), press and release RESET
when viewing that particular counter's screen.
5. When finished, press NEXT to advance counter
screens until the display reads BREW COUNTERS.
Press and release NO to advance to the next
function screen, or press and release either of the
pads on the front switch panel to exit the
BREW COUNTERS function and return to the MAIN
SCREEN.
FUNNEL DETECT (optional)
This function allows the operator to prevent the
start of a brew cycle if a Smart Funnel
tioned correctly in the funnel rails.
Procedure to set funnel detect:
1. Press and hold the ® pad until the display reads
SET NEW RECIPES. Release the ®. Press and
release the ® pad until the display reads FUNNEL
P2308
DETECT.
2. NO or YES should be flashing to indicate the
current setting.
4. Select YES to prevent brewing if a Smart Funnel
is not correctly situated in the rails. If this function
is activated and a brew cycle is attempted with the
funnel not properly situated, the display will read,
FUNNEL NOT IN PLACE, until one is in place.
5. Select NO to allow brewing without a Smart Fun-
®
nel in place. This is selected when brewing with
a funnel other than a Smart Funnel
brew funnel).
6. When finished, press and release DONE. This will
retain the changes, exit this function screen and
advance to the next. Another alternative is to press
either of the
panel to exit the FUNNEL DETECT and return to the
MAIN SCREEN.
Page 31

FUNNEL DETECT ?

pads located on the front switch
® is not posi-
P2309
®
® (a regular
29877 121302