Bunn Dual SH Installation And Operating Manual page 38

TROUBLESHOOTING (cont.)
Screen Displayed
Possible Cause
®
1. Soft Heat Server was moved out
of position after the brew cycle was
started.
1. ON/OFF switch was pressed after
the brew cycle was started.
1. Tank Heater failure
2. Triac Failure
3. Control Board/Thermistor failure
Page 38
Troubleshooting Procedures
To resume brewing, correctly posi-
®
tion the Soft Heat Server and press
BREW again. The brew cycle re-
sumes from the point it was inter-
rupted.
OR
Press ON/OFF to terminate the brew
cycle.
To resume brewing, press BREW
again. The brew cycle resumes form
the point it was interrupted.
OR
Press ON/OFF to terminate the brew
cycle.
Service Required
Service Required
Service Required
29877 090401