Table of Contents
Advertisement
OVEN STARTUP
1. Check that the Emergency STOP Button [E] is pulled out.
2. Turn on the POWER Switch [A] of the Control Panel.
- Indicator lamp illuminates.
3. Set the HEAT Switch [B] of the Control Panel to "ON".
- The RED upper Digital Display [D] shows the initial Oven ambient temperature then quickly climbing.
- The lower GREEN Digital Display shows "400" [D].
- Center indicator lamp illuminates.
4. Set the FAN Switch [C] of the Control Panel to "ON".
- Fan will run. Lower indicator lamp illuminates.
5. If any of the above functions are not performing, depress the STOP Button [E] immediately and determine cause.
6. When the correct function of Oven Controls has been verified, proceed to OVEN OPERATION.
OVEN OPERATION
The Oven may emit burning odors during the first use.
FULL USE OF OVEN
• Start Oven as described above.
• Allow Oven temperature to climb and reach 400°F (as indicated in the RED digi-
tal display) [D] (FIG 2). This should require less than 20 minutes when starting
with a 70°F ambient temperature.
The Temperature Controller [D] is pre-set at the factory to go to
and hold 400°F. Expect a +/- 6 F temperature fluctuation with
the door kept closed and during powder cure.
The temperature can be overridden to a lower or higher set point (example
350°F/450°F) however after the power to the Temperature Controller [D] is shut off
and turned on the next time, it will default back to 400°F.
The temperature cannot be overridden to exceed 450°F
TO OVERRIDE:
- Press the (▲) Key on the Temperature Controller [D] to raise the temperature set
point then press the "SET" Key to lock it in.
- Press the ( ▼ ) Key Temperature Controller [D] to lower the temperature set point
then press the "SET" Key to lock it in.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 2
5
Advertisement
Table of Contents
