Brother HL-1260 Service Manual page 68

(4) Take off the halogen heater from the heater support spring, remove the halogen heater by
pushing it and pulling the heater support spring at the same time ( A ).
Heater support spring
A
Halogen heater
(5) Loosen 4 screws and remove the thermistor lead wire connector (2P) of the fixing PCB (see
Figure 4.51), and remove the fixing unit cover by detaching the wire from the hooks of the fixing
unit chassis.
Hooks
(6) Loosen a screw and remove the fixing PCB assy.
A
Figure 4.48
Screws
Screw
Fixing unit
C
Figure 4.49
Screws
Fixing unit chassis
Figure 4.50
Fixing PCB assy
Figure 4.51
IV - 20
Support spring Pull
A
A
Heater Push
B
Halogen heater
Fixing unit cover
Connector