Advertisement
Error Message
31 PRINT OVERRUN
32 BUFFER ERROR
34 MEMORY FULL
40 LINE ERROR
41 PRINT CHECK
Table 6.3 Error Messages
Meaning
Print overrun
Input buffer overflow
Work memory overflow
Error in the
communications circuit
Error in communication
with the engine controller
VI - 27
Action
Press the CONTINUE
switch to start printing
the next page. Data
which overran the print
area on the page cannot
be printed. Check your
page protection setting
with the MODE switch.
Setting page protection
to the correct size could
solve this problem. If
printing at 600 dpi, you
may need to add optional
SIMM memory.
Press the CONTINUE
switch to resume
printing. Data lost in
overflow cannot be
printed.
Press the CONTINUE
switch to resume
printing. If the same error
should occur after you
press the CONTINUE
switch, turn off the
printer. Wait a few
seconds, then turn it on
again . Reduce the input
buffer size. Turn off
"KEEP PCL." Add SIMM
memory with power off.
Download font and the
font saved in the HDD
card might cause the
error, for it occupies the
same work area as the
RAM. Memory expansion
is recommended in that
case.
When the serial interface
is used, check the
communications
parameters such as baud
rate, code type, parity,
and handshake
protocols. When the
parallel interface is used,
check the interface cable
connection.
Turn off the printer. Wait
a few seconds, then turn
it on again. See M-17.
Advertisement
Chapters
Troubleshooting
