Agilent Technologies Infiniium 9000 Series User Manual page 4

9000 Series Oscilloscopes -- At a Glance
• Graphical interface menus and toolbars simplify complex measurement
setups.
Horizontal controls set sweep speed and position
• Main sweep speeds from 5 ps/div to 20 s/div.
• Intensified waveforms on main sweep window make it easy to see what will
appear in the zoom window.
Acquisition and general controls start and stop the scope and do basic
setup
• Run and stop controls for continuous or single acquisitions.
• Clear display before one or more acquisitions.
• Default setup and Autoscale set initial configuration.
Hard disk drive and USB 2.0 port for saving and restoring setups and
measurement results
• Store measurement displays for inclusion in reports and test setup guides.
• Store oscilloscope setups to repeat tests another time.
• Hard disk stores oscilloscope operating system.
Trigger setup controls set mode and basic parameters
• Select Edge, Glitch, or Advanced Modes.
• Choose input source and slope.
• Use graphical user interface to simplify configuration of pattern, state,
delay, and violation trigger modes.
Vertical controls set attenuation and position
• Input attenuation adjustable from 1 mV/div to 1 V/div.
• Color-coded knobs make it easy to find the controls that affect each
waveform.
Marker and quick measurements help measure waveform parameters
• Waveform markers A and B to check voltage or Δ-time at any point on the
displayed waveform.
4