Agilent Technologies Infiniium 9000 Series User Manual page 23

The display will pause momentarily while the oscilloscope adjusts the sweep
speed and vertical scale. You should then see a square wave with peak-to-peak
amplitude of approximately 5 divisions and about four cycles on screen. If you
do not see the waveform, ensure your power source is adequate, the
oscilloscope is properly powered-on, and the probe is connected securely to
the front panel connector.
5
Move the mouse around the mouse surface and verify that the on-screen
pointer follows the mouse movement.
6
Touch the pointer of the touch screen stylus to the surface of the screen and
move it around while verifying that the pointer follows the movement.
Setting Up the Oscilloscope
23