Advertisement
Assembly Instructions
STEP 5
Note the correct position of the BASE STANDS(1) in the illustration below. The
longer ends of the BASE STANDS(1) point to the HEADREST(7).
Attach the BASE STANDS(1) to the PIVOT SUPPORTS(2) with BUTTON
HEAD BOLTS(M6x1x60mm)(15), LOCK WASHERS(M6)(10), and ACORN
NUTS(M6x1)(11).
STEP 6
Adjust the distance between the two FOAM PADS(8) so the HEADREST(7)
can be fitted in. Position the HEADREST(7) with its longer side pointing
upward and attach to the CONNECTING BAR(4) with BUTTON HEAD
BOLTS(M6x1x35mm)(13).
Longer Side
BACK VIEW
Longer End
(After Assembly)
Longer End
3
Advertisement
