Advertisement
Assembly Instructions
NOTE: Do not tighten any bolts until STEP 4.
STEP 1
NOTE: CONNECTING BAR(5) is the one without holes in its middle section.
The HANDRAILS(6) have the FOAM GRIPS(9) attached to them.
Insert the HANDRAILS(6) into the CONNECTING BAR(5) and secure with
BUTTON HEAD BOLTS(M6x1x30mm)(12), LOCK WASHERS(M6)(10), and
ACORN NUTS(M6x1)(11).
STEP 2: Insert the HANDRAILS(6) into the PIVOT SUPPORTS(2) and secure
with BUTTON HEAD BOLTS(M6x1x40mm)(14), LOCK WASHERS(M6)(10),
and ACORN NUTS(M6x1)(11).
STEP 3: Slide a FOAM PAD(8) onto each end of the CONNECTING BAR(4),
but don't cover the screw holes on either end. Insert the HEADREST
SUPPORTS(3) into the CONNECTING BAR(4) and secure with BUTTON
HEAD BOLTS(M6x1x30mm)(12), LOCK WASHERS(M6)(10), and ACORN
NUTS(M6x1)(11).
STEP 4: Insert the HEADREST SUPPORTS(3) into the PIVOT SUPPORTS(2)
and secure with BUTTON HEAD BOLTS(M6x1x40mm)(14), LOCK
WASHERS(M6)(10), and ACORN NUTS(M6x1)(11). Tighten all bolts from
STEP 1 to STEP 4.
Foam Grip(9)
Foam Grip(9)
2
Advertisement
