Using The Remote Printer Console Main Program - Brother HS-5000 Quick Setup Manual

the DOS prompt.
3. Insert the supplied disk into your floppy disk drive (A: or B:).
4. Select the drive to be used by typing A:
or B: after the DOS prompt and
pressing the Enter key.
5. Type RPCSETUP and press the Enter
key.
6. Follow the instructions that the installer gives you.

Using the Remote Printer Console Main Program

Type C:\RPCX>RPCX and press the Enter
key to start the Remote Printer Console
main program.
The Main Screen will appear on your
computer screen as shown on the right.
The RPC gets the current settings information from your printer when it starts if bi-directional
communication is enabled between your computer and printer. Otherwise, the RPC shows its
default settings. If you want to change settings, move the cursor to the desired item and select the
desired setting by using the Enter and Cursor keys. Then press the Enter key to make the selected
setting valid. If you use a mouse, click the desired item to change the setting.
There are four sub-menus as shown in the table below. Select the sub-menu by clicking the
desired sub-menu with the mouse, by using the cursor key and the Enter key, or by using the keys
shown below to switch the screen to the sub menus.
Menu Press the keys Functions
Direct Access Alt + D
Printer Setup Alt + P
Console Config Alt + C
Guide Alt + G
On-lineHelp F1
14
C:\>A:
A:\>RPCSETUP
You can directly control the printer functions such as
Print Form, Self Print, Reset Printer and Printer
immediate Sleep mode.
You can enter the Setup mode to change further printer
settings such as margin settings, continue mode, reprint
function, font and sleep mode timeout.
You can change the environment settings for the RPC
program: color, Status Monitor configuration and so
forth.
You can get into the Guide mode.
You can get on-line help if you press F1. You will get
information on the currently highlighted item.