Northern Lights NLFTPR150 Assembly Instructions Manual page 7

Parts required for this page:
Item
Part
No
T Cable Handle
V Cable
Assembly for right
side is detailed, left
side is opposite.
17.Start installing the Cable Assembly (V)
at the Dual Swivel Pulley Brackets (6).
Feed the end with the ball shank
between the two pulleys and proceed
in numbered sequence finishing at the
Adjustable Pulley Slide (5).Make certain
that the cable rests in the pulley grooves
and is under the Cable Retainers.
18.Remove the Selector Fork, lift the
Selector Shaft (26) and position the
Cable Assembly (V) ball shank end in
the slot in the bracket on the
Adjustable Pulley Slide (5).
19.To adjust the cable tension, loosen the
jam nut on the Pulley U Bracket (20)
and remove pulley and rotate
the Pulley U Bracket (20), clockwise or
counterclockwise as required. Reinstall
the Pulley U Bracket (20) and tighten
the jam nut.
NOTE: Make certain that the cables
are properly positioned
on/around pulleys before use.
Cables are a consumable and must be treated as such. As a minimum, an annual
inspection must be performed on all cable ends and full lengths.
A cable must be replaced immediately if broken exposed wires and/or a break
in cable coating are found.
QTY.
2
2
START 1
T
22
3
V
2
8
FINISH
19
6
7
21
5
20
4
18
Page:-7 of 9