BMW R 1200 GS 2014 Rider's Manual page 35

The up arrow indicates an in-
flation pressure problem on the
front wheel. The down arrow
indicates an inflation pressure
problem on the rear wheel.
Possible cause:
The measured tire inflation pres-
sure is outside the approved tol-
erance range.
Check tire for damage and
suitability for continued use.
If it is still possible to drive with
tire:
Correct tire inflation pressure at
the next opportunity.
Before adjusting the tire in-
flation pressure, observe
the information on temperature
compensation and on inflation
pressure adjustment in the chap-
ter "Technology in detail".
The RDC warning message
can be deactivated in the
off-road mode.
Have the tire checked for dam-
age at an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
If you are unsure about the tire's
suitability for continued riding:
Do not continue riding.
Contact roadside service.
Sensor defective or
system error
with Tire Pressure Control
OE
(TPC/RDC)
The general warning lamp
lights up yellow.
The tire symbol with one or
two arrows appears.
-- -- --
" " or " " is indicated.
Possible cause:
Wheels without installed TPC/
RDC sensors are mounted.
Retrofit wheel set with TPC/
RDC sensors.
Possible cause:
1 or 2 TCP/RDC sensors have
failed or a system error has oc-
curred.
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Transmission error
with Tire Pressure Control
OE
(TPC/RDC)
-- -- --
" " or " " is indicated.
Possible cause:
The motorcycle has not reached
the minimum speed (
RDC sensor is not active
min 19 mph (min 30 km/h)
(The RDC sensor does not
transmit a signal to the motor-
cycle until this minimum speed
has been exceeded.)
3
33
z
104).