BMW R 1200 GS 2014 Rider's Manual page 123

Tighten the right-hand axle
clamping screw 1 with the
specified torque.
Clamping screw for
quick-release axle in
telescopic fork
14 lb/ft (19 Nm)
Remove front wheel stand.
Slide the brake calipers on the
left-hand and right-had side
onto the brake rotors.
Install securing screws 4 on left
and right with specified torque.
Brake caliper on tele-
scopic forks
28 lb/ft (38 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
disks.
Before driving off, check that the
braking effect kicks in without
any delay.
Engage the brakes repeatedly,
continuing until the brake pads
seat against the rotors.
Locate wheel speed sensor
lead in the retaining clips 1
and 2.
Insert wheel speed sensor in
bore and install screw 3.
Wheel speed sensor on
fork
Joint compound: Micro-
encapsulated or medium-
strength screw lock
6 lb/ft (8 Nm)
Removing rear wheel
Make sure ground is level and
firm and place motorcycle on
its center stand.
Shift into first gear.
Risk of skin burns from hot
exhaust system.
7
121
z