Miele CS 1011 Converting Instructions page 16

Converting CS 1028
Changing the jet
^ Remove the two screws a of the
burner pipe on the underside of the
appliance.
^ Pull off the burner pipe b.
^ Unscrew air intake sleeve c.
16
^ While using a 19 mm wrench to
prevent it the gas tube from twisting,
unscrew the jet c counterclockwise
using a 14 mm wrench (see
illustration).
^ Install the new jet using the same
procedure.
^ Reassemble the burner parts in the
reverse order and check for leaks by
operating the burner without the
combiset surface in place (use a
match to ignite the flame).