Miele CS 1011 Converting Instructions page 12

Converting CS 1012
After conversion
^ After converting the cooktop, affix the
label supplied with the conversion kit
on to the data plate over the type of
gas stated.
^ Reassemble the burner parts in the
reverse order.
^ Check all gas fittings for leaks by
operating the burners without the
combiset surface in place (use a
match to ignite the flame).
^ Remove the burner parts again.
^ Replace the combiset surface.
^ Screw the burner bases into place,
and replace the other parts of the
burners. Take care to reassemble the
burners in the correct order.
^ Replace the control knobs.
^ Light each of the burners in turn to be
sure they are operating correctly.
When set at "low" or when the control
knob is quickly turned from "high" to low
the flame should not go out.
When set at "high" the gas flame must
burn with the center clearly visible.
12