GE Profile Series Owner's Manual page 12
Side by side refrigerators
Hide thumbs
Also See for Profile Series:
- User manual ,
- Owner's manual and installation instructions (152 pages) ,
- Owner's manual & installation instructions (56 pages)
Table of Contents
Advertisement
Available languages
Available languages
About storage drawer removal.
Not all features are on all models.
When replacing the drawers, make
sure you slide them through both
drawer guides on the right side.
12
Drawer Removal
Drawer Guides
Drawers can easily be removed by tilting up slightly and
pulling past stop location.
Remove the door bins from the fresh food door before removing the
drawer.
To remove the shelf above the top drawer, first remove
the top drawer and any food on the shelf. Then tilt the
shelf up at the front and lift it up and out of the tracks.
To replace the shelf, raise the shelf front slightly and
place the top hooks in the lowest large track slots. Then
lower the front of the shelf until it is level.
To remove the drawers when the fresh food
compartment door cannot be opened fully you need to
roll the refrigerator forward until the door can be fully
opened. In some cases this will require moving the
refrigerator to the left as you roll it out.
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Profile Series and is the answer not in the manual?
Questions and answers
Does the water filter light turn green when filter is installed properly on Model# PFCF1PJYA WW?
Our hands-free GE profile refrigerators auto fill is shutting off before sensing full says error
The hands-free Autofill feature on the GE Profile refrigerator is designed to fill containers up to approximately 90% full using ultrasonic sensors to detect the container size. It shuts off before sensing full to prevent overflows and spills by stopping short of completely filling the container.
This answer is automatically generated
My water in the door (GE Profile Performance circa 2000) is taking upto 10 seconds to dispense water after a day or two of non use. Where can l look to solve this issue? Also last night water was coming out from under the fridge. I installed an heavy 3/16" plate under the fridge so the wheels wouldn't cause a dent in the floor and make it hard to initially move. The water was between the plate and the floor but the top of the plate was dry. Where do l start to look for a solution? Thank you very