Disassembly Of Parts - Invacare Octave User Manual

3.7 Mounting the mattress support extension (10 cm)
Note! It is not possible to use the wooden side rail in combination with the mattress support extension.
Therefore dismount the wooden side rails first.
The mattress support extension can be mounted in either the head- or foot end
or in both ends.
a) Loosen screws from the bed end.
b) Remove the bed end.
c) Remove the ferrules in the tube ends for the mattress support
and mount the extension.
d) Tighten up with the enclosed screws.
e) Mount the bed end in the outer position (4 screws per fitting).
(Visible insert pipe is about 14.5 cm).

4. Disassembly of parts

4.1 Dismounting mattress support - from the base
The mattress support can be disassembled from the base. To disassemble the mattress support from the base
relevant tools and 2 persons are required.
a) Dismount all accessories incl. bed end.
b) Lower the bed into the lowest position.
c) Dismount the height adjustment motor cable from the control unit.
d) Raise the back section to the highest position.
e) Loosen and remove the screws/nuts between mattress support
and shear arms.
f) Lift the mattress support free from the guideway.
g) Lower the back section to the lowest position.
h) Remove the power plug from the bed and lift the mattress support
off the shear arm.
4.2 Dismounting the BRITT V/Line Alu side rail
a) Raise the bed about one third.
b) Place the side rail in the highest position.
c) Dismount the end stop brackets. (4 pcs.).
d) Lower the side rail, (see section "Operation of the BRITT wooden/Line Alu side rail") until it is completely
below the bed end rail.
14