• Place the Slip Roller on a clean, stable, level surface at a comfortable working height. Mount securely to the work surface using 4 suitable 5/16" [8mm]
lag screws or bolts (not included) through the four 21/64" [8.3mm] diameter holes in the base.
• Install the two Thickness Adjustment Pins by threading them into the locations in the upper front faces of the Roller Side Frames (Fig 1).
• Slip the square broached hole in the Crank Handle over the square drive end of the Lower Front Roller and tighten set screw with a 3mm hex key
(not included) (Fig 2).
• Install the two Rear Roller Knobs by threading them onto the locations in the rear of the slip roller (Fig 3).
Fig. 1
Thickness
Adjustment Pin
Fig. 2
To order parts and supplies: 800.345.1178 >> eastwood.com
Align the dimple in the hole on the top roller and insert the
bolt so the taper sits in the dimple. Tighten the locknuts.