Advertisement
Table of Contents
- 1 Step 1: Insert Front and Rear Strut Assemblies and Center Hub into Body Sleeve
- 2 Step 2: Connect Rear and Front Strut Assemblies to Center Hub
- 3 Step 3: Attach Spinner Axle to Rear Strut Assembly
- 4 Step 4: Install Spinner Wheels Onto Spinner Axle
- 5 Step 5: Assemble Front Spinner Using Second Spinner Axle and Wheels
- 6 Step 6: Install Support Pole and Ground Stake
- Download this manual
WindGarden
b y
p r e m i e r
d e s i g n s
w w w . p r e m i e r k i t e s . c o m
Velcro
Rear
Strut
Wheel
Assembly
Fitting
Step 1
The Strut Assembly of your Red Wagon spinner is shipped in three sections. Open Velcro Tabs on the Red Wagon Body Sleeve and insert the Front Strut
Assembly and the Rear Strut Assembly into the Sleeve. Both the Front Frame and the Rear Frame should be inserted so that the Wheel Fitting is closer to
the edge of the wagon than the center. Please note that the Front Frame and the Rear Frame are identical and can be used interchangeably. Insert the
Center Hub into the Sleeve. (diagram A)
Step 2
Once the Front Strut Assembly, the Rear Strut Assembly, and the Center Hub are in place within the Body Sleeve, connect the Rear Strut Assembly to the
Center Hub. Then Connect the Front Strut Assembly to the Center Hub. (diagram B)
Red Wagon Spinner
Body Sleeve
Center
Front
Hub
Strut
Wheel
Assembly
Fitting
sku #26828
Open
Body Sleeve
Rear Strut Assembly
will have to be
connected to
Center Strut Assemby
assembly
instructions
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
Front Strut Assembly
will have to be
connected to
Center Strut Assemby
Advertisement
Table of Contents
Related Manuals for Premier designs WindGarden 26828
Summary of Contents for Premier designs WindGarden 26828
- Page 1 Red Wagon Spinner WindGarden assembly p r e m i e r d e s i g n s instructions w w w . p r e m i e r k i t e s . c o m sku #26828 Completed Internal Strut Assembly.
- Page 2 Red Wagon Body Spinner Wheel Spinner Axle Axle First, slide Spinner Axle onto Strut Assembly Second, tighten knob on "T" Joint Wheels on same axle Slide Spinner should spin "T" Joint Wheels onto Spinner in opposite Axle, then hammer directions Axle Cap onto end Step 3 Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of Red Wagon...
Need help?
Do you have a question about the WindGarden 26828 and is the answer not in the manual?
Questions and answers