Premier designs WindGarden 26829 Assembly Instructions

Dune buggy spinner

Front Strut Assembly

will have to be

connected to

Internal Body Struts

Body Sleeve

Step 3

Remove your Dune Buggy Spinner from the package. The Strut Assembly is shipped in three sections. Open the Velcro seam along the

bottom of the Dune Buggy. Connect the Rod of the Front Strut Assembly to the Star Lock Hub of the Internal Rear Strut Assembly.

(Diagram A)

Step 2

Slide the narrow, plastic tipped end of the Support Pole into Star Lock Hub. Push down on the hub until The Support Pole locks into place

and cannot be removed. Close Velcro Seam. (Diagram B)

Dune Buggy Spinner

sku #26829

Star Lock Hub

Rear Strut Assembly

(Internal Body

Struts)

Velcro

Seam

Completed Internal Strut Assembly.

Make sure all parts connect as shown.

Body Sleeve

Plastic Tip of Support Pole

Support Pole

assembly

instructions

Star Lock Hub

Push Star Lock Hub rmly

onto Plastic Tip of Support Pole

NOTE: To make insertion process

easier, place bottom of Support Pole

on a hard, at surface and push

down on Star Lock Hub.

Table of Contents

Need help?

Do you have a question about the WindGarden 26829 and is the answer not in the manual?

Page 1 Dune Buggy Spinner assembly instructions sku #26829 Completed Internal Strut Assembly. Make sure all parts connect as shown. Front Strut Assembly Star Lock Hub will have to be connected to Internal Body Struts Rear Strut Assembly (Internal Body Struts) Star Lock Hub Body Sleeve Body Sleeve Velcro...
Page 2 Dune Buggy Body Dune Buggy Body Slide Spinner Wheels onto Spinner First, slide Spinner Axle, then hammer Axle onto Axle Cap onto end Strut Assembly Axle Cap Second, tighten knob on "T" Joint Wheels on same axle Spinner "T" Joint should spin Axle in opposite...