Check Control Messages - Cimbali FAEMA Use And Installation

13. Check Control Messages

The check-control messages are divided into two groups:
1. Messages in explicit mode: they position on the last line at the bottom of the Display (5). They are cancelled on each
2. Messages in code: these appear in the top right-hand corner with the following syntax:i: Exxx
When there are several errors, their representation is timed, passing in succession on the display.
MESSAGE POSSIBLE CAUSES: when the message is visualized
Machine cold 1. This message appears on the display after a dispensing
key has been pressed when:
- the services boiler pressure is below the preset operating
pressure;
- the boiler temperature is below 60°C.
When the operating pressure and temperature are
reached, the message will disappear automatically.
2. When the services boiler or the coffee boiler cannot
respectively reach the operating pressure and temperature
due to problems, an error code will appear on the display
identifying the defective component that caused the problem.
Check Boiler This message is displayed when the machine is switched
This message means that the coffee ground drawer is
Grounds
drawer full full.
10 more coffee selections (or 5 double dose) may be
made (coffee-based drinks) before the machine is
blocked and the following message is then displayed.
The machine counts in decreasing order the pre-set
Empy drawer
maximum grounds number. This message means that
that value run out. The machine is blocked and no cof-
fees beverages can be delivered.
This message always appears when the back side of
Grounds
drawer the drawer is not in the right position.
removed
Tray extracted This message (accompanied by the icon on the display)
always appears when the tray is not positioned properly.
the boiler
This message is displayed when the machine requires the
Service needed
periodic maintenance intervention. In order to eliminate
temporary the message, keep pressed RES key for ap-
proximately 8 seconds. The message will reappears in the
successive relighting of the machine with the main switch.
new cycle and then appear again if the cause that generated them returns
Messages in explicit mode
32 EN
where: · E indicates an error;
· xxx rappresents the error code of the unit.
VERIFICATIONS
2. Consult the technical manual and refer to
on the display to solve the problem
Worker has not intervened.
Empty the drawer to reset the counter or
wait until when the machine will display the
message 'empty drawer'.
Consult the technical manual to program the
number of grounds to the attainment of which
the message will be visualized.
Remove the coffee grounds drawer.
Empty the drawer and replace it in the correct
position. Close the panel. During this opera-
tion the message 'Groun. Draw. Removed'
will be displayed.
If this message appears when the drawer
is inserted, check the drawer is correctly
positioned.
Make sure the tray is correctly positioned.
This operation is performed automatically
and requires no action by the user.
This operation does not impede the hot water
delivery.
Contact the authorized technical depart-
ment. The message will be displayed until
the service will be carried out. (Refer to the
Technician's Manual).