Table of Contents
Advertisement
1 General information
About this document
The language
of the original operating
instructions is English. All other languages of
these instructions are translations of the
original operating instructions.
These installation and operating instructions
are an integral part of the product. They must
be kept readily available at the place where
the product is installed. Strict adherence to
these instructions is a precondition for the
proper use and correct operation of the
product.
These installation and operating instructions
correspond to the relevant version of the
product and the underlying safety standards
valid at the time of going to print.
Supplied pump will operate trouble free and
satisfactorily on the condition that, it is
installed with due care and maintained
properly.
For
hassle
free
recommended that the pump should operate
under specified "Operating conditions". Pump
operating conditions are mentioned on the
"Nameplate" affixed to the pump.
If operating parameters deviate from the
specified parameters as on the "Nameplate",
please contact manufacturer."
2 Safety
These operating instructions contain basic
information which must be adhered to during
installation and operation.
these operating instructions must, without
fail, be read by the service technician and the
responsible operator before installation and
commissioning. The machine operator
must be filled out completely. By signing this
list, all persons working on or with the product
confirms that they have received, read and
understood this operating
manual.
It is not only the general safety instructions
listed under the main point "safety" that must
be adhered to but also the special safety
instructions with danger symbols included under
the following main points.
2.1 Designation of information in the
operating instructions
Symbols:
General danger symbol
Danger due to electrical voltage
NOTE: ...
Signal words:
DANGER!
Acutely dangerous situation
Installation and operating instructions Wilo – SCPV pumps
operating
life,
it
is
For this reason,
list
& maintenance
Non-observance results in death or the most serious of
injuries.
WARNING!
The user can suffer (serious) injuries. "Warning"
implies that (serious) injury to persons is probable if
this information is disregarded.
CAUTION!
There is a risk of damaging the pump/installation.
"Caution" implies that damage to the pro- duct is
likely if the information is disregarded.
Useful information on using the product. It also draws
attention to possible problems.
2.2 NOTE:
Personnel qualifications
The installation prsonnel must have the appropriate
qualification for this work.
2.3 Danger in event of non-observance of the safety
instructions
Non-observance of the safety instructions can result
in risk of injury to
product/installation. Non-observance of the safety
instructions can result in the loss of any claims to
damages.
In detail, non-observance can, for example, result in
the following risks:
Failure of important product/installation functions
Failure
of
required
procedures
Danger to persons from electrical, mechanical and
bacteriological influences
Property damage
2.4 Safety consciousness on the job
The safety instructions included in these installation
and operating
instructions,
regulations for accident prevention together with any
internal working, operating and safety regulations of
the operator are to be complied with.
2.5 Safety instructions for the operator
This appliance is not intended
(including children) with reduced physical, sensory or
mental
capabilities, or lack of experience
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
If hot or cold components on the product/the unit
lead to hazards, local measures must be taken to
guard them against touching.
Guards
protecting
components (such as the coupling) must not be
removed whilst the product is in operation.
Leakages (e.g. from the shaft seals) of hazardous
fluids (which are explosive, toxic or hot) must be led
away so that
no danger to persons or to the
environment arises. National statutory provisions
are to be complied with.Highly flammable materials
are always to be kept at a safe distance from the
product.
persons
and damage
maintenance
and
repair
the existing national
for use by persons
against
touching
moving
7
to
and
Advertisement
Table of Contents
Need help?
Do you have a question about the SCPV and is the answer not in the manual?