Removing The Protective Parts; Loading The Paper - Brother MFC-210C Quick Setup Manual

Step 1
Removing the Protective
1
Parts
1
Remove the protective tape and paper.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.

Loading the Paper

2
You can load up to 100 sheets of 80 g/m
paper.
For more details, see "About paper" in
Chapter 1 of the User's Guide.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
2
Press and slide the paper guide to fit the
paper width.
Paper Side Guide
2
Setting Up the Machine
3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
2
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful not to push the paper too far
into the paper tray so it does not slide up
the back of the tray.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
Paper Support