Setting Up The Machine; Removing The Protective Parts; Installing The Handset (Mfc-620Cn Only); Loading Paper - Brother MFC-210C Quick Setup Manual

Step 1
Removing the Protective
1
Parts
1
Remove the protective tape.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
Installing the Handset
2
(MFC-620CN only)
1
Connect the curled handset cord to the
handset.

Loading Paper

3
You can load up to 100 sheets of 20 lb
paper.
For more details, see "About paper" in
Chapter 1 of the User's Guide.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
4

Setting Up the Machine

2
Press and slide the paper guide to fit the
paper width.
Paper Side Guide
3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
■ Make sure the paper side guides touch the
sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
Paper Support