Electrolux ECFI3068AS Use & Care Manual page 43

Oven maintenance
Removing the shelf supports
IMPORTANT
This has to be done in order to replace the oven
lights and enables you to clean the oven side walls.
• Grasp the shelf supports firmly by both ends to
prevent scratching the enamel of the oven cav-
ity when removing them.
• Wear protective gloves.
To remove the shelf supports:
1. Pull the frame towards the inside of the oven to
unhook it from its groove A, then slide it out of
the seats B at the back.
1. When cleaning is complete, repeat the above
procedures to put the self supports back in.
Replacing the oven light
WARNING
ELECTRIC SHOCK HAZARD -
Make sure the range is unplugged
and that all parts are COOL
before replacing oven light. Wear
a leather-faced glove for protec-
tion against possible broken glass
or burns.
IMPORTANT
The oven is fitted with two 120V - 40W halogen light
bulbs.
CARE AND CLEANING
The oven lights will automatically turn ON when the
oven door is opened. The oven lights may also be
manually operated by turning the oven temperature
knob to the bulb icon (see "Inside lights").
The oven light bulb is covered by a glass shield. The
glass shield can be removed to be cleaned manually
or for replacing the oven light bulb. THIS GLASS
SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS
IN USE.
To replace the oven lights:
1. Turn the power off at the main source or unplug
the appliance.
2. Remove the bulb cover using a tool that cannot
scratch the enamel surfaces (e.g. a spoon).
1. Slide out the light bulb and remove it.
2. Install the new light bulb.
NOTE
Do not allow your fingers to touch the new bulb
when installing it. This will shorten the life of the new
bulb. Use a paper towel to cover the new bulb when
installing it.
43