Pilz PSEN op2H-A Series Operating Manual page 51

OPERATING MANUAL
Muting active
Override active
Normal
Override status
operating
mode
Muting only
Override timing error
Lamp error
OSSD error
Microprocessor error
Lens error
Error
EDM error
information
Restart error
Communication error
BCM
error
1003069-EN-03
Configuration
PSEN op2H-A series
If the OSSDs switch off
unintentionally and
during active muting,
check the partial muting
configuration.
Activate the override
button to bridge OSSDs
to light
Check and repeat the
override activation
sequence.
Check the override
connections.
Check the lamp
connections and check
for any potential defects
on the lamp.
Activate RESET.
If the problem should
persist, please contact
Pilz customer services.
Activate RESET.
If the problem should
persist, please contact
Pilz customer services.
Activate RESET.
If the problem should
persist, please contact
Pilz customer services.
Activate RESET.
Check the EDM feedback
line and the EDM
configuration.
Check connection
RESTART
/RESET/REALIGN.
Activate RESET.
Check the cascading
connection and check
that the terminator cap is
installed correctly.
Perform basic
configuration again.
If the problem should
persist, please contact
Pilz customer services.
51