Panel-Mounted Instruments - ABB 4600 Series Operating Instructions Manual

...3.2 Mounting
3.2.2 Panel-mounted Instruments – Figs. 3.4 and 3.5
Dimensions in
mm (in)
96 (3.78)
96
(3.78)
1
Cut a hole in the panel (see Fig. 3.4 for dimensions).
Instruments may be close stacked to DIN 43835.
Loosen the retaining screw
on each panel clamp.
Remove the panel clamp and
anchors from the instrument case.
Refit the panel clamps to the case, ensuring that the
5
panel clamp anchors are located correctly in their slot.
Secure the instrument by tightening
6
the panel clamp retaining screws.
Caution. The clamp must fit flat on the
instrument casing. If the clamp is bowed, the securing
screw is overtight and sealing problems may occur.
12 (0.47) 191 (7.52)
Fig. 3.4 Overall Dimensions
2
3
3
Fig. 3.5 Panel Mounting
3 MECHANICAL INSTALLATION
+0.8
92 (3.62
–0
Panel Cut-out
Insert the instrument
into the panel cut-out.
+0.03
)
–0
+0.8
92
–0
+0.03
(3.62 )
–0
4
5