Advertisement
Figure 1
5. Sliding the Removeable Handle (W) over Finger #2, push down and outward to secure the unit under the
handle catch for the transport position. Adjust the Leveling Pads (B) until the Portable Base (A) extension
arm is level front to back and the base is level side to side when the Portable Base (A) is lowered back onto
the Leveling Pads (B). Tighten the bottom jam nut tight against the bottom of the Portable Base (A).
Lower the unit onto the Leveler Pads (B). See Figures 1, 2 & 5.
6. Level the Backboard (J) and the Breakaway Goal (L) from side to side and tighten all hardware. Using the
leveling screws on the top and bottom of the extension arm level the Backboard (J) top to bottom.
Tightening the top screw will raise the front of the Breakaway Goal (L) and tightening the bottom screw
will lower the back of the Breakaway Goal (L). See Figure 6.
When tightening one screw you will need to loosen the opposite screw when leveling the backboard.
Never use the backboard to push/pull the system as unwarranted backboard breakage may occur.
7. Recheck the Backboard (J) and Breakaway Goal (L) ensuring they are still level. Readjust as necessary.
8. Without attaching the Backboard Braces (E), remove Lock (V) from the hitch pin, pull hitch pin from the
telescoping height adjuster and raise the goal to the 10' playing position and re-insert the hitch pin and
Lock (V). See Figure 7.
Failure to follow all instructions may cause backboard breakage.
Note:
Warning!
Figure 4
IMPORTANT:
2
Figure 3
Figure 2
Figure 5
Advertisement
