Table of Contents
Advertisement
LAUNCH
Installation & Connection
1. CNC-602A Installation
1)
Move the machine onto the workbench after
unpacking and loosen the strips on the outlet
hoses.
2)
Mount the pulse signal cables onto the socket on
the right top side of the machine.
3)
Take the two adjusting bolts out from the kit and
install them to the press plate on the top of the
glass tube.
4)
Take the two knurled nuts from the kit and install
them on the adjusting bolts.
5)
Take the fuel distributor from the kit and install it on
the knurled nuts and tighten them with the pressing
bolts.
2. CNC-601A/801A Installation
1) Take the pulse signal cables from the box and insert
it into the socket on the top right side of the machine
and tighten it.
2) Take the pulse signal cables from the box and insert
it into the socket on the right upper of the ultrasonic
cleaner and tighten them.
3) Take the two adjusting screws out from the box and
install them to the press plates on the top of the glass
tubes.
4) Take the two knurled nuts from the box and install
them on the adjusting screws.
5) Take the fuel distributor from the box and install it on
the knurled nuts and tighten them with the pressing
screws.
3 Ordinary Connection
1) Take the power cables out from the kit and insert it into the input socket at the bottom of the unit.
2) Take the power cables out from the kit and insert it into the input socket of the ultrasonic cleaner.
Operating Procedures
Preparation
1) Remove the injector from the vehicle engine to check
the o-rings inside for damage. Replace the damaged
O-ring with another same type O-ring to avoid leakage
during testing. Put the outside of injectors in gasoline
or detergent, and wipe them with soft cloth after
cleaning the outside oil sludge carefully.
2) Check the liquid level and refill test liquid when
necessary. Fill the test liquid through the filler on the
side of the unit and observe the liquid level in the fuel
level viewer. In most cases, filled the liquid up to 1/2 of
the tank capacity.
Injector Cleaner & Tester User's Manual
1-Outlet hose; 2-Pulse signal cables; 3-Fuel distributor
assembly; 4-Adjusting bolts; 5-Knurling nut.
1-Outlet hose; 2-Top-supply fuel distributor assembly;
3-Adjusting screw; 4-Knurled nut.
3) Turn on the power switch on the right of the Cabinet.
4) Fill ultrasonic detergent into the ultrasonic cleaning
launder so that the needle valve of the injector is
covered by the detergent.
5) Connect the injectors with the right couplers.
Note:
Test liquid and detergent are provided together with the
unit. The test liquid is used for uniformity/sprayability
test, leakage test, injecting flow test and auto. test.
The mixture of fuel and detergent is used in on-vehicle
cleaning. The ultrasonic cleaning uses special injector
detergent (or test liquid and detergent that comes with
by the unit).
4
Fig.03
Fig.04
Hide quick links:
Advertisement
Table of Contents
