Baofeng UV-9G User Manual page 31

This function is used to set the display mode of channel B.
Display modes:
• FREQ.: Frequency + channel No. • CH: Channel number
• NAME: Channel name
Note: Channel name mode must be set by the programming software. Up to three numbers or characters can be edited.
(24) Busy Channel Lock (BCL) - MENU No. 23
When this function is on, it may prevent other radios' interference. If the selected channel is being used by other radios,
when you press key PTT, your radio cannot transmit.
Release the PTT and transmit as soon as the frequency is no longer busy.
(25) Auto Keypad Lock (AUTOLK) - MENU No.24
When this feature is activated, the keypad will be automatically locked after 15s; this prevents accidental pressure of any
keys.
(26) Frequency offset direction (SFT-D) - MENU No.25
Using this function, you can set the direction of the frequency offset in rx and tx.
You have the following options:
＋: Positive offset; －: Negative offset;
OFF: no offset
Note: you should set different frequency deviation according to the repeaters selected. This function is not enabled in
channel mode.
(27) Frequency offset (OFFSET) - MENU No. 26
In this MENU you can set the deviation between tx and rx. The frequency offset of this radio is 0-69.990MHz.
(28) Channel store - (MEM-CH) - MENU No. 27
When the radio is in frequency working mode or standby mode, input the desired frequency or parameters directly.
To set a CTCSS tone or a DCS code in tx or rx on the stored channel, refer to paragraphs MENU 10-13
Note: You cannot overwrite a stored channel, you have to delete it first. See following paragraph No.28.
(29) Channel Delete (DEL-CH) - MENU No.28
28