(In An Existing Pool/After Electrical Requirements Are Met) - Pentair INTELLIBRITE 5G Installation And User Manual

4
Replacing the IntelliBrite
(After Electrical Requirements Are Met)
The following removal and installation instructions describe how to remove and
install the IntelliBrite pool and spa light assembly. Also use these instructions
after completing the following light replacement procedure:
• IntelliBrite Spa Light and Face Ring Gasket and Lens Removal and
Installation instructions, on page 19.
Failure to bring the pool or spa's electrical system up to code requirements
before installing the underwater light will create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due
to electrical shock, and may also cause damage to property.
1. WARNING! Switch off main electrical switch or circuit breaker, and the
switch which operates the IntelliBrite underwater light.
2. To remove light fixture assembly from the pool. Remove the special
bronze pilot screw at top of face ring. Remove the IntelliBrite light assembly
from the niche and place it on the deck.
3. Cut the cord about 12 inches (30.5 cm) from the back of the light
assembly.
4. Remove Junction Box cover, disconnect the light fixture wires, and
pull the cord through the conduit. Tip: Before pulling the cord, tape
the new cord to the existing cord, This might make it easier to
feed the new cord through the conduit (see following step).
5. Feed the new light fixture cord through the conduit from the niche
to the Junction Box. Note: Depending on the length of the conduit,
special tools may be required to pull the cord through the conduit.
6. Leave at least four (4) feet of cord to coil around the light fixture;
see Figure 1 on page 6. This four (4) feet (1.2192 m) of cord coiled
around the light allows the light to be serviced after the pool is filled
with water.
7. Cut the cord at the Junction Box, leaving at least size (6) inches of
cord to make connections.
8. Strip six (6) inches (15.2 cm) of the outer cord jacket from the cord
to expose the three insulated conductors. B
the insulation on the three (3) inner conductors).
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
Light Assembly
®
5G Pool and Spa
e careful not to damage
Strip a 1/2" of insulation