Electrical Connection - Pentair MICROBRITE Installation And User Manual

10
EXTERNAL SAFETY ISOLATION TRANSFORMER :
Using an External Safety Isolation Transformer for Multiple 12 VAC MicroBrite Lights
When using multiple MicroBrite 12 VAC ~ lights on a 100 Watt safety isolation transformer, it is recommended that
no more than six (6) MicroBrite color lights be used. For long cable lengths for each light, it is recommended not to
exceed 45 m of total cable run between the 12 VAC isolation transformer and the MicroBrite color light.
Transformer compliant with NF EN 61558-2-6
Maximum Wattage using multiple color (with a 300 Watt isolation transformer).
IMPORTANT! When using multiple 12 VAC Pentair pool and spa lights the total allowable light wattage should not
exceed 80% of rated value.
The individual light wattage is as follows:
• One MicroBrite Color Pool LED light is 12 Watts
maximum
• One IntelliBrite-e Pool Color LED light is 40 Watts
maximum
• One IntelliBrite-PAR56 Color LED light is 40 Watts
maximum
Powering on the MicroBrite color lights
When the MicroBrite color light is powered on, the previously selected color is displayed, unless the HOLD or
RECALL feature was previously enabled.
Note: If power to the light is off for more than five (5) seconds, the last color show mode or fixed color that was
saved will be displayed.
MicroBrite color led light for pool and spa Installation and User' s Guide

ELECTRICAL CONNECTION

Junction box
Wire connectors
2A
2A
• Up to six (6) MicroBrite 12 V AC lights can be con-
nected on a 100W transformer.
• Up to twenty (20) MicroBrite 12 V AC lights can be
connected on a 300W transformer.