Pentair INTELLIBRITE 5G Installation And User Manual page 24

20
3. Using a #3 Phillips head screwdriver, loosen the CLAMP SCREW and
remove uni-tension wire clamp from the face ring.
4. Remove the face ring and wire clamp from the light housing and set
aside for installation later.
Note: A 120 VAC to 12
VAC external transformer
is required for the 12 VAC
model IntelliBrite
Light. See page 1 for more
information.
Note: The IntelliBrite Spa
Light fixture is a sealed light
assembly with no replaceable
circuit board assembly. Only the
lens, gasket and face ring can
be removed from the sealed light
assembly for replacement. See
page 23 for replacement kit part
numbers.
5. With the light assembly resting on its base, carefully pry off the gasket to
release the lens. Discard the gasket. A NEW LENS GASKET MUST BE
USED EACH TIME THE SPA LIGHT IS REASSEMBLED
6. Disconnect the IntelliBrite spa light assembly cord from the junction box.
Cut the cord near the back of the light assembly and discard the
light. See page 4 for replacement instructions for the new spa light.
Cut cable and discard
light assembly
Spa light assembly
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
®
Spa
Discard old
gasket
Lens
(keep
lens)
Spa light fixture with lens, gasket
and face ring attached
Phillips screw
Face ring and uni-tension
wire clamp
Loosen the
Phillips screw
to remove wire
clamp from
face ring