Cleaning The Inside Of The Cooler; Defrosting The Cooler; Adjust Temperature - WMF CUP&COOL Manual

Care
4.3

Cleaning the inside of the cooler

™ Stir 5 ml of the WMF special cleaner (order
no. 33 0683 6000) from the measuring bottle into
a bucket containing 0.5 l of lukewarm water
™ Use this stirred cleaning solution to wipe out the inside
of the cooler
™ Wipe again using clean water
™ Wipe dry using a soft cloth
™ Replace the milk containers
™ Close the door
4.4

Defrosting the cooler

If the ice layer is more than 3 mm thick, defrost the
cooler. For coolers with integrated low-level messages,
any ice build-up on the rear vertical wall should be
avoided.
This helps to avoid malfunctions and saves energy.
™ Switch off the cooler using the ON/OFF switch
™ Disconnect mains plug
™ Leave the front door open
™ Wipe away the water from melting ice with a soft cloth
Never remove the ice layer with sharp or pointed objects.
The surface of the interior of the cooler could be
damaged.
Do not use heating appliances (hair dryer, heat gun, steam
cleaners, etc.) to defrost.
™ Close the front door before switching on again
4.5

Adjust temperature

™ Remove the cap on the back of the cooler
Turn clockwise
Turn counter clockwise g warmer *
A quarter turn is approx. 2K.
* The stop for the warmest setting has a slight detent. Turning past the
detent will switch off the device.
30
g colder
Caution.
Health hazard.
Follow the instructions of the
label on the cleaning agents.
Follow the manual.
Observe the Safety chapter.
User Manual WMF Cup / WMF Cup&Cool