Moog Infinity Quick Reference Instructions page 2

Programming and Running the Pump
These instructions are not a substitute for the operator's manual.
Be sure to read the operator's manual thoroughly prior to operating
the pump. See other side for pump operation instructions.
Hang the feeding
Hang feeding container so that the bottom of the bag
container
is at or above the level of the pump door (image A).
Turn on the pump
Press and hold the
seconds to turn the pump on. The display
will show the last programmed rate.
To program the
Press the
rate (how fast in the lower-left corner of the screen. Use
your pump runs) the
To program the Press the
dose (how much lower-left corner of the screen. Use the
is to be fed) to program the dose. Note: If "FEED INTERVAL" is
on the display, clear feeding interval by pressing
the
To program
If "FEED INTERVAL" is on the display, clear feeding
a continuous
interval by pressing the
feeding (rate
the
only setting) display "DOSE" in the lower-left corner of the screen,
and hold the
To program an
Press the
interval feeding
lower-left corner of the screen. Use the
(or intermittent to program the dose. Press the
feeding) display "FEED INTERVAL" in the lower-left corner
of the screen. Program the desired number of
hours and minutes using the
Start the pump Press the
When feeding
When feeding is complete, press the
is complete
key for 1.5 seconds to turn the pump off.
To clear settings
Press the
value. Press and hold the
seconds to reset rate, dose, feed interval, and
volume delivered values at the same time.
View volume Press the
delivered delivered for the current feeding. Press the key
again to display the total cumulative volume
delivered since the total volume was last reset.
Infinity® is a registered trademark of Zevex, Inc. Moog® is a registered trademark of Moog, Inc.
© 2021 Moog, Inc. Moog Medical, 4314 Zevex Park Lane, Salt Lake City, UT 84123 USA. LS-26015-001 Rev. D
ON/ OFF
key for 1.5
RATE/DOSE
key to display "RATE"
+ -
and keys to program the rate.
RATE/DOSE key to display "DOSE" in the
FEED INT
key, then press the
FEED INT
CLEAR RATE/DOSE
key. Press the
+
key until the displays reads INF.
RATE/DOSE
key to display "DOSE" in the
RUN/PAUSE key to start the pump.
CLEAR
key to reset the displayed
CLEAR
VOL/TOTAL key once to display volume
+ -
and keys
CLEAR
key.
key, then press
key twice to
+ -
and keys
FEED INT
key to
+ -
and keys.
ON/OFF
key for 3
A
ON/OFF
RATE/DOSE
RATE/DOSE
FEED INT CLEAR
FEED INT CLEAR
RATE/DOSE RATE/DOSE
RATE/DOSE
FEED INT
RUN/PAUSE
ON/OFF
CLEAR
VOL/TOTAL