Install The Mulch Plug; Set The Blade/Cutting Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks LME367 Operator's Manual

EN
4. Close the rear discharge flap.
3.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge flap.
3.6 SET THE BLADE/CUTTING
HEIGHT
The machine can be set to different blade/cutting heights.
Figure 6.
1. Push the height adjustment button, move the height adjust
gear to a higher position to increase the blade/cutting
height.
2. Push the height adjustment button, move the height adjust
gear to a lower position to decrease the blade/cutting
height.
3.7

INSTALL THE BATTERY PACK

Figure 7
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
USE ONLY 24V BATTERY. DO NOT USE DUAL-
VOLTAGE 24/48V BATTERY.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery flap.
The motor starts only when you put in the safety key.
WARNING
WARNING
NOTE
NOTE
English
3.8

REMOVE THE BATTERY PACK

Figure 7
1. Open the battery compartment flap
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 8
1. Put in the safety key and battery.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the
direction of the handle bar.
4. Release the start button to start the machine.
4.2

STOP THE MACHINE

Figure 8
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
4.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
4.4

OPERATE ON SLOPES

Do not mow on slopes with incline more than 15°. If you
are not comfortable, do not mow on a slope.
6
WARNING
WARNING
WARNING
WARNING