U-Line H-7690 User Manua page 2

2. Insert post into slot in back support. Use one
8 x 10 mm screw to secure. (See Figure 2)
NOTE: Install post so side marked "outward" will
face away from seat cushion.
NOTE: Use Allen wrench to tighten screws.
Figure 2
3. Align armrest with holes on bottom of seat cushion.
Use four 6 x 24 mm screws to attach. Repeat on
opposite side. (See Figure 3)
Figure 3
4. Align mechanism with holes on bottom of seat
cushion. Use six 6 x 24 mm screws to attach.
(See Figure 4)
NOTE: For clearance to tighten screws, pulling
out seat slider lever and moving mechanism
forward or backward may be necessary.
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
5. Insert back support post into socket in mechanism
on bottom of seat cushion. Use one 10 x 23 mm
screw to secure. Place cover over post and use two
4 x 20 mm screws to attach using Phillips screwdriver.
(See Figure 5)
6. Slowly lower assembled chair, setting mechanism
onto the gas lift. Press down on seat cushion to
secure. (See Figure 6)
Figure 5
Figure 6
0521 IH-7690