Valet Mode - Firstech CM900 Master Manual

CM900 Master Guide
STEP 2: Within a 2 second period after the 5th ignition cycle tap (a quick 0.5 second press and release)
the Lock button on the Firstech remote. The parking lights will flash once to confirm the
transmitter has been coded. Repeat step 2 for each additional remote, up to 4.
Remote programming procedure: PTS (Push to Start vehicles) application
STEP 1: Set the vehicle to the ignition or "ON" position
STEP 2: Within 5 seconds push to the "OFF" position
STEP 3: Within 5 seconds set the vehicle to the ignition or "ON" position (do not start)
STEP 4: Within 5 seconds depress and release the foot brake 3 times *parking lights will flash 1 time to
indicate remote programming is enabled
STEP 5: Tap (a quick 0.5 second press and release) the lock button on the remote * the parking lights
will flash 1 time indicating the remote code has been accepted (Repeat step 5 for each
additional remote, up to 4
STEP 6: After 10 seconds of no valid remote codes being transmitted the CM will automatically
exit programming mode

Valet Mode

Valet Mode disables all system features except for the keyless entry. Use Valet when servicing or loaning your
vehicle to others to avoid any inconvenience or mishap when operating the vehicle. There are no visual
indicators when the security system is in Valet Mode. There is a parking light indication when remote starting in
Valet Mode. (3 flashes followed by 10 flashes). Also, when in Valet Mode, the keyless entry feature will still
operate.
The system can be put into valet mode one of 3 ways:
1. While holding the foot brake (12V+ brake input), cycle the key to the Ignition or 'On' position and then back
to the 'Off' position 5 times within 10 seconds. The parking lights will flash once indicating that the system
has entered Valet Mode.
2. Turn the key to the Ignition or 'On' position then using a 4-button remote press and release the lock and
trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode.
Copyright 2018 Firstech ,
LLC.
Note: if you only have 2 remotes please program each remote twice.
**parking lights will flash twice signaling the end of programming mode.
Alarm and Starter System
www.firstechdata.com
Page 6