Maintenance And Cleaning - Sunrise Medical Jay Basic Owner's Manual

932165RevB New Basic Back.qxd:Layout 1
E N G L I S H
MAINTENANCE
Sunrise recommends that all fasteners be checked for wear, such as
loose bolts or broken components every 6 months. Loose fasteners
should be retightened according to the installation instructions. All
fasteners should be tightened to torque specifications as stated in
the hardware installation section. Contact your authorized Sunrise
Medical supplier immediately to replace any broken components.
Do not continue to use the system after identifying loose or broken
components.
EASY CLEANING
1. CLAMP HARDWARE VERSIONS
Remove back from the wheelchair. Detach foam and cover from alu-
minum shell. Locate the zipper on bottom of cover and unzip.
Remove foam and turn cover inside out. Zip cover closed to avoid
snagging. Machine wash cover in warm water (60°C). Drip or Tumble
dry on low heat. Reinsert the foam inside the cover and zip the cover
closed.
NOTE: Do not dry clean covers or use industrial washers and dryers to clean
cover. Do not steam autoclave. Do not bleach.
To clean back shell:
Shell may be wiped clean with soap and water. No other mainte-
nance should be required.
2. STRAP & SUPPORT VERSION
Loosen straps and remove back from the wheelchair. Locate the
zipper on bottom of cover and unzip. Remove foam and plastic
support shell and turn cover inside out. Zip cover closed to avoid
snagging. Machine wash cover in warm water (60°C). Drip or tum-
ble dry on low heat. Reinsert the foam and support shell inside the
cover and zip the cover closed.
932165 Rev. B
8/20/08 11:57 AM Page 4
NOTE:
NOTE–
To clean back shell:
Shell may be wiped clean with soap and water. No other mainte-
nance should be required.
If you have any additional questions regarding cleaning procedures,
please contact your authorized Sunrise Medical dealer.
4
M A I N T E NA N C E A N D C L E A N I N G
Do not dry clean covers or use industrial washers and dryers to clean
cover. Do not steam autoclave. Do not bleach.
The ABS plastic support shell is designed to be placed inside the
cover to provide additional support to the back.
Laundry Care Symbols
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean